Home / DIY / ADHESIVE / EVERBUILD RAPID EPOXY METAL SYRINGE ADHESIVE 24ML

EVERBUILD RAPID EPOXY METAL SYRINGE ADHESIVE 24ML

EVERBUILD RAPID EPOXY METAL SYRINGE ADHESIVE 24ML
EVERBUILD RAPID EPOXY METAL SYRINGE ADHESIVE 24ML

EVERBUILD RAPID EPOXY METAL SYRINGE ADHESIVE 24ML.

Rapid Epoxy Metal is a two part adhesive which sets hard in just 5-10 minutes and is ideal for bonding of metal and metal alloys as well as glass, ceramic and wood, it finishes to a grey metal like appearance.
Due to it’s exceptionally high bond and repair strength this product can be drilled, sanded, machined and painted once fully cured. It offers good tensile and impact strength as well as good chemical and heat resistance.
APPLICATION
Ensure surfaces are clean, dry and are free from flaking material, dust, rust and grease. Roughen surfaces with sandpaper
to improve adhesion.
Remove cap from centre of twin plunger and snap off tab from bottom of nozzles.
Use plunger to push out equal lengths of resin and hardener onto a clean disposable surface. Replace cap on nozzles,
Mix thoroughly for 30 secs to 1 minute with mixing stick provided. Mixed adhesive is usable for only 4 minutes. Only
mix small quantities in one go.
Apply adhesive immediately to both surfaces. Assemble and hold/clamp until adhesive starts to cure. Note; Adhesive
will cure faster at higher temperatures and conversely, slower at low temperatures. At 20`C, the adhesive sets hard in 10
minutes and is fully cured in 12 hours. RAPID EPOXY METAL is temperature resistant from -20 to +70`C.
Carefully remove any residual adhesive with a sharp knife before adhesive sets.
 PRICE £ 3.50

Comments

comments

Check Also

BOSTIK BLU TACK HANDY PACK

BOSTIK BLU TACK HANDY PACK

BOSTIK BLU TACK HANDY PACK. Product description This Bostik Blu Tack Handy Pack brings you …

Leave a Reply

Your email address will not be published. Required fields are marked *

Free WordPress Themes